We are manufacturing Retarders for plaster of paris. It is a very fine powder that is obtained by heating Gypsum. We are among the renowned suppliers of Retarder Plaster of Paris that is used extensively by the construction industry in the interiors as well as exteriors of the walls.
More Keywords :- retarders for plaster of paris,gypsum retarder compound We are the producer and exporter for gypsum retarders use to produced plasters of various setting time and enhancing properties
|Colour/Form||free-flowing brownish to cream powder|
KEY PROPERTIES :- cost-effective thixotropic agent for mineral-based construction systems Improved ease of application and surface smoothness Increased sag resistance and softness Decreased pumping pressure and stickiness on tools Anti-sedimentation and anti-bleeding Stability against bacteria and enzymes . Plasters, Renderings and Stucco
1- Lime cement plaster
2- EIFS plaster and adhesive system
3- Emulsion plasters/synthetic stucco
4- Skim coats
5- Gypsum plasters
Joint fillers Plasterboard jointing compounds Gypsum, latex and cement pointing compounds . Screeds and Underlayments Self leveling flooring compounds Cementitious and gypsum anhydrate screeds .
LEVELS OF USE
The usage and dosage of retarder will depend on nature and purity of gypsum plaster The level of addition depends on the desired consistency of the system. Typical levels range from 0.1% - 3.0% additive, based on total formulation.
In plasters typically 0.1% - 0.3% are used can be combined with other thickening agents.
Potential Health Effects
Acute inhalation not expected to result in adverse effects.
Prolonged inhalation may cause respiratory tract irritation.
Effects include: No other effects expected unless listed below.
Eye contact causes irritation.
Skin contact causes irritation.
Prolonged skin contact can result in irritation causing redness and itching.
Not expected to be harmful if absorbed through the skin.
Harmful if ingested.
Effects include: Nausea, pain, vomiting, diarrhea and digestive tract irritation.
FIRST AID MEASURES
Wash with soap and water. If discomfort or irritation persists, consult a physician. Remove contaminated clothing and wash before reuse.
Flush eyes with water for at least 15 minutes while holding eyelids open. If discomfort or irritation persists, consult a physician.
Rinse mouth with water. Give the person one or two glasses of water and then consult physician.In extreme emergency, induce the victim to vomiting under professional supervisions.
No hazard in normal industrial use. If symptoms develop, get fresh air, and if symptoms persist, consult a physician. If breathing has stopped, give artificial respiration then oxygen if needed.
HANDLING AND STORAGE
Avoid contact with eyes, skin and clothing.
Do not take internally.
Practice good personal hygiene to avoid ingestion.
Use only with adequate ventilation.
Wash clothing before reuse.
FOR PROFESSIONAL USE ONLY. KEEP OUT OF CHILDREN’S REACH.
EXPOSURE CONTROL /PERSONAL PROTECTION
Ventilation must be adequacy.
Personal Protective Equipment
Common rules:D o not eat, drink and smoke at working place. Avoid to longtime contact the substance and breathe the dust of the substance. Change the contaminated clothing and wash it.
Rubber or other impervious gloves should be worn to prevent skin contact.
At minimum, safety glasses with side shields should be worn where exposure to excessive dust or spry is likely.
Use good personal hygiene practices. None beyond those noted above.
STABILITY AND REACTIVITY
Keep away from the heat, direct sunlight and fire.
Conditions To Avoid
Hazardous Decomposition Products
This substance will not decompose hazardously.